Installing a jon boat seat clamp is a simple job, until you actually attach the seat to the clamp. It takes a little more ingenuity to get it tight. We’ll go over the steps on how to install a jon boat seat clamp and what special DIY tool you can use to make the job much easier.
Tools and materials
You will need the Swivl-Eze boat seat clamp, a boat seat, and a screwdriver or wrench. You’ll also need another DIY tool for tightening the wing nuts on the clamp after the seat has been installed. This is basically a pvc pipe with a notch in the end that fits under the boat seat and around the wing nut. See the video above for more on that.
Steps to install the Swivl-Eze boat seat clamp
Follow these steps:
- Attach the boat seat to the seat clamp with bolts. Your boat seat should have come with hardware to do this. Use a wrench or screwdriver to tighten the bolts.
- Position the clamp: Determine the desired location for the boat seat and position the Swivl-Eze clamp accordingly. Ensure that the area is clear of obstructions and that the clamp will be securely attached to the boat.
- Place the clamp: Slide the open clamp onto the boat’s bench seat and slide the bars in or out to adjust to the width of the mounting surface.
- Tighten the clamp down fully with the wings nuts and special PVC tool.
- Test the seat: Sit on the boat seat and ensure that it feels secure and stable. Adjust the seat position or tighten the mount if necessary.
- Double-check everything: Once the seat is installed, inspect all the connections, clamps, and hardware to ensure they are tightened properly and secure.
Conclusion:
This is a simple project but it’s important to use the right tools and get the seat clamp as tight as possible. A slip in the seat clamp can put you overboard in a hurry